Back to marketplace
Adjustable Desk-Edge Cable Holder with Five Side-Entry Pockets

Adjustable Desk-Edge Cable Holder with Five Side-Entry Pockets

By Jonathon Ringeisen · Saved version 2

Organize cables along a desk edge with this single-piece, slide-on U-shaped holder. The default design has a 25 mm desk opening and five 4 mm cable pockets on an exterior rail. Rounded side entries are narrower than the pockets, allowing cables to be inserted from the edge while remaining accessible from above when installed. The parametric OpenSCAD source lets you adjust desk thickness, fit clearance, clip depth, cable diameter, pocket count, spacing, wall thickness, entry width, and corner radius. The source limits entry width relative to pocket diameter and checks for spacing between pockets. The model is oriented on one end for printing. Desk fit and cable retention should be checked with a test print, particularly with the default zero added clearance. Available formats: STL, 3MF, and OpenSCAD.

Copy this community design to your library to customize it and download your saved version.

Log in to copy

Saved parameters

Values from version 2. Units are shown where supplied by the creator. These are model inputs; check the exported geometry and fit in your slicer.

Parameters for saved version 2
Parameter Value
Nominal desk thickness25.5
Extra clearance added to the desk opening0
Distance the clip reaches onto the desk30
Cable pocket diameter4
Number of cable pockets5
Cable pocket center-to-center spacing9
Structural wall and flange thickness2.4
Width of the narrower cable entry3.2
Radius of rounded exterior profile corners0.8

The creator has not added print notes yet. Check dimensions, orientation, supports, and material settings before printing.

Make this design your own

  1. Copy to your library. Log in and use “Copy to my designs” to create a private, editable copy.
  2. Adjust and preview. Change exposed parameters, edit the OpenSCAD code, or ask AI for changes. Save a new version when ready.
  3. Export and check. Download STL or 3MF for your slicer, or editable OpenSCAD. Check dimensions, build volume, orientation, and print settings.