Measured models for your desk

Custom cable holder generator

Keep several cables in separate round channels. Set the cable diameter, channel count, and top opening, then preview an editable holder with a solid base.

Set your cable dimensions

Dimensions are in millimeters. Clearance increases the channel diameter. An opening ratio of 1 leaves the full channel width open at the top.

Previewing needs no account. Creating a holder uses one design from your allowance. No AI message is needed for the starting model.

Measure the cable body

Use the cable jacket diameter, then choose channel clearance. A large connector may not pass through the channel; the top opening provides a separate insertion path to inspect.

Inspect your print setup

Check the base, upper channel surfaces, orientation, and supports in your slicer. Previewed geometry does not establish flexibility or a successful fit with your material.

Keep editing the source

The holder opens as a private, parameterized OpenSCAD design. Save your own versions and export STL, 3MF, or OpenSCAD from the studio.

Choose a measured starting point

Start small, test the important fit, and keep the saved version that matches your result.