Back to marketplace
Floating-Disc Dog Water Bowl with Bone-Shaped Drinking Opening

Floating-Disc Dog Water Bowl with Bone-Shaped Drinking Opening

By Jonathon Ringeisen · Saved version 4

This customizable three-piece dog water bowl design combines a flared-base bowl, a floating-disc insert with a recessed bone-shaped drinking opening, and a retaining ring with six clip arms. The OpenSCAD source provides separate part selection and an assembly preview. Editable parameters cover bowl diameter and height, wall and floor thickness, base flare, disc clearance and thickness, drinking recess dimensions, bone-opening proportions, and retaining-ring clip geometry. Chamber width and skin thickness controls define the disc’s enclosed air-chamber geometry. The floating-disc concept depends on watertight construction; the preview position is illustrative rather than a verified water level. Available formats are STL, 3MF, and OpenSCAD.

Copy this community design to your library to customize it and download your saved version.

Log in to copy

Saved parameters

Values from version 4. Units are shown where supplied by the creator. These are model inputs; check the exported geometry and fit in your slicer.

Parameters for saved version 4
Parameter Value
Part: 0 bowl, 1 floating disc, 2 retaining ring, 3 assembly preview3
Bowl outside diameter above the flared base230
Bowl height78
Bowl wall thickness3.2
Bowl floor thickness4
Wide stabilizing base diameter250
Inside floor bevel5
Radial clearance around floating disc3.8
Floating disc maximum thickness15
Float skin and chamber separation thickness2
Depth of the central drinking recess12
Radius of the flat recessed drinking area42
Overall bone-shaped opening length64
Diameter of the four rounded bone lobes16
Width of the narrow bone shaft12
Radial width of each sealed annular air chamber14
Clear diameter through the retaining ring190
Retaining ring flange thickness3
Length of the retaining ring clip arms12
Thickness of the flexible clip arms1.6
Tangential width of each clip arm14
Radial clearance between clip arms and bowl0.5
Depth of the snap groove in the bowl0.8

The creator has not added print notes yet. Check dimensions, orientation, supports, and material settings before printing.

Make this design your own

  1. Copy to your library. Log in and use “Copy to my designs” to create a private, editable copy.
  2. Adjust and preview. Change exposed parameters, edit the OpenSCAD code, or ask AI for changes. Save a new version when ready.
  3. Export and check. Download STL or 3MF for your slicer, or editable OpenSCAD. Check dimensions, build volume, orientation, and print settings.