Back to marketplace
iMac Drawer Stand

iMac Drawer Stand

By Landon Ringeisen · Saved version 16

Maximize every inch of your desk ecosystem with this custom-engineered organizer that mounts directly into the neck space between your iMac stand and display. Designed to seamlessly integrate with your hardware, it adds three convenient storage drawers for small accessories and a built-in front iPhone holder to keep your device upright and in view—turning dead space into your desk's most productive zone.

Copy this community design to your library to customize it and download your saved version.

Log in to copy

Saved parameters

Values from version 16. Units are shown where supplied by the creator. These are model inputs; check the exported geometry and fit in your slicer.

Parameters for saved version 16
Parameter Value
Part: 0 assembly, 1 shell, 2 lid/holder, 3 three drawers, 4 floor, 5 one drawer, 6 joint test0
Overall organizer width240
Overall organizer depth118
Case height excluding lid31.8
Structural wall and floor thickness2.4
Lid thickness2.2
Clearance on each side of a drawer0.5
Drawer outside depth104
Drawer front finger-scoop radius9
Overall width of flat back support110
Phone angle from horizontal78
Distance from organizer front to retaining wedges5.5
Measured phone thickness including any case6.35
Extra clearance for buttons and easy removal2
Front retaining wedge height8
Flat back support vertical height32
Thickness of flat back support3.2
Front-to-back base depth of triangular wedges8
Width of each retaining wedge12
Center-to-center spacing of retaining wedges70
Phone short-edge allowance including case80
Maximum total height above desk including phone114.3
Maximum drawer unit height including lid60.325
Wave repeat length26
Wave vertical amplitude3
Width of decorative openings2.4
Vertical spacing between wave rows14
Solid border around patterned panels5
Depth of shallow pattern grooves in the box rear wall0.8
Soft rounding radius of holder profile corners0.8
Lid corner radius in plan view1.2
Inset of slim lid upper edge bevel0.6
Spacing of horizontal retaining-wedge end grooves4
Height of each retaining-wedge end groove0.8
Shallow groove depth into retaining wedge ends0.45
Snap pin stem diameter3.6
Radial running clearance in snap sockets0.2
Radial snap catch projection beyond stem0.45
Flexible pin length8
Split width in flexible pins1
Solid root length below pin split1.2
Rear connector block width and depth10
Axial clearance at the ends of sockets0.3
Numerical boolean overlap0.02

The creator has not added print notes yet. Check dimensions, orientation, supports, and material settings before printing.

Make this design your own

  1. Copy to your library. Log in and use “Copy to my designs” to create a private, editable copy.
  2. Adjust and preview. Change exposed parameters, edit the OpenSCAD code, or ask AI for changes. Save a new version when ready.
  3. Export and check. Download STL or 3MF for your slicer, or editable OpenSCAD. Check dimensions, build volume, orientation, and print settings.